No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
port-isolate enable

port-isolate enable

Function

The port-isolate enable command enables port isolation.

The undo port-isolate enable command disables port isolation.

By default, port isolation is disabled.

Only the AD9431DN-24X supports this function.

Format

port-isolate enable [ group group-id ]

undo port-isolate enable [ group group-id ]

Parameters

Parameter

Description

Value

group group-id

Specifies the ID of a port isolation group.

The value is an integer that ranges from 1 to 64.

Views

GE interface view, XGE interface view, port group view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

To implement Layer 2 isolation between interfaces, add different interfaces to different VLANs. This, however, wastes VLAN resources. To save VLAN resources, enable port isolation to isolate interfaces in a VLAN. That is, you can add interfaces to a port isolation group to implement Layer 2 isolation between these interfaces. Port isolation provides secure and flexible networking schemes for customers.

Precautions

  • After port isolation is configured, ports are isolated at Layer 2 but can communicate at Layer 3 by default. To configure both Layer 2 isolation and Layer 3 isolation, run the port-isolate mode all command.

  • Interfaces in a port isolation group are isolated from each other, but interfaces in different port isolation groups can communicate. If group-id is not specified, interfaces are added to port isolation group 1 by default.

Example

# Enable port isolation on GE0/0/1.

<Huawei> system-view
[Huawei] interface gigabitethernet 0/0/1
[Huawei-GigabitEthernet0/0/1] port-isolate enable group 1
Translation
Download
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 212618

Downloads: 122

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next