No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
radio-type (2G radio profile view)

radio-type (2G radio profile view)


The radio-type command sets the radio type in a 2G radio profile.

The undo radio-type command restores the default radio type in a 2G radio profile.

By default, the radio type in a 2G radio profile is dot11n.


radio-type { dot11b | dot11g | dot11n }

undo radio-type






Specifies the 802.11b radio type.



Specifies the 802.11b/g radio type.



Specifies the 802.11b/g/n radio type.



2G radio profile

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

You can run the radio-type command to set the radio type in a radio profile.


If a rate in the basic rate set or supported rate set, or the multicast rate is not supported by the 802.11b protocol, the radio type cannot be set to 80211b.

When the radio type is set to dot11b or dot11g, the function of denying access from non-HT STAs becomes invalid.

If you run the radio-type dot11b command in the 2G radio profile view to set the radio type to dot11b, and the 2G radio profile is applied to an RU, the rates of Beacon frames and multicast packets that take effect on the 2 GHz radio of the RU are fixed as 1 Mbps, and the values configured using the beacon-2g-rate beacon-2g-rate and multicast-rate multicast-rate commands do not take effect on the RU.


# Set the radio type to dot11g in a 2G radio profile.

<Huawei> system-view
[Huawei] wlan
[Huawei-wlan-view] radio-2g-profile name default
[Huawei-wlan-radio-2g-prof-default] radio-type dot11g
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 196736

Downloads: 122

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next