Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
rf-ping
Parameters
| Parameter | Description | Value |
|---|---|---|
| -m time | Specifies the interval for sending probe data packets. | The value is an integer that ranges from 100 to 10000, in milliseconds. The default value is 1000. |
| -c number | Specifies the number of probe data packets sent by the AP. | The value is an integer that ranges from 1 to 1000. The default value is 1. |
| -p { be | bk | vi | vo } | Specifies the priority of probe data packets sent by the AP, which can be AC_BE, AC_BK, AC_VI, or AC_VO. If this parameter is not specified, the default priority is AC_BK. | - |
| mac-address | Specifies the MAC address of a STA. | The value is in H-H-H format. An H is a hexadecimal number of four digits. |
Usage Guidelines
Use Scenario
You can run this command to obtain wireless link parameters, including the signal strength, data rate on the air interface, and packet transmission delay.
Prerequisites
STAs have been associated with the APs and gone online.
Example
# Configure the device to automatically detect quality of the link between the AP and STA with the MAC address 14cf-9202-13dc.
<Huawei> system-view [Huawei] wlan [Huawei-wlan-view] rf-ping 14cf-9202-13dc Tx rate=52.0 Mbps, Reply from 14cf-9202-13dc: RSSI=-58 dBm time < 1 ms 1 packets transmitted, 1 received, 0% packet loss, time < 1 ms, RSSI -58 dBm
Previous
