No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
calibrate max-tx-power

calibrate max-tx-power

Function

The calibrate max-tx-power command sets the maximum transmit power that can be adjusted through radio calibration.

The undo calibrate max-tx-power command restores the default maximum transmit power that can be adjusted through radio calibration.

By default, the maximum transmit power that can be adjusted through radio calibration is 127 dBm.

Format

calibrate max-tx-power power

undo calibrate max-tx-power

Parameters

Parameter

Description

Value

max-tx-power power

Specifies the maximum transmit power that can be adjusted through radio calibration.

The value is an integer that ranges from 1 to 127, in dBm.

Views

RRM profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

After radio calibration is enabled, an AP uses the Transmit Power Control (TPC) algorithm to calculate the transmit power to be adjusted based on detected neighbor information. If the transmit power to be adjusted calculated using the TPC algorithm is to large, signal interference between APs may occur. You can run the calibrate max-tx-power command to set the maximum transmit power that can be adjusted through TPC.

Precautions

The maximum radio calibration power must be larger or equal to the minimum radio calibration power. You can run the calibrate min-tx-power command to set the minimum calibration power.

You can adjust the maximum and minimum calibration powers using the calibrate max-tx-power and calibrate min-tx-power commands. The valid power after radio calibration is between the two values. If the values are set improperly, the maximum and minimum calibration power settings may fail to take effect.
  • If the maximum calibration power is smaller than the minimum transmit power of an AP, the minimum transmit power takes effect. For example, if the minimum transmit power of an AP on the 2.4 GHz band is 9 dBm and the maximum calibration power is set to 8 dBm, the transmit power on the 2.4 GHz band is 9 dBm after radio calibration.
  • If the minimum calibration power is larger than the maximum transmit power of an AP, the maximum transmit power takes effect. For example, if the maximum transmit power on the 2.4 GHz band is 21 dBm and the minimum calibration power is set to 25 dBm, the transmit power on the 2.4 GHz band is 21 dBm after radio calibration.

Example

# Set the maximum transmit power that can be adjusted through radio calibration to 30 dBm.

<Huawei> system-view
[Huawei] wlan
[Huawei-wlan-view] rrm-profile name default
[Huawei-wlan-rrm-prof-default] calibrate max-tx-power 30
Translation
Download
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 194955

Downloads: 118

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next