No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
vrrp vrid track admin-vrrp vrid

vrrp vrid track admin-vrrp vrid


The vrrp vrid track admin-vrrp vrid command binds a VRRP group to an mVRRP group.

The undo vrrp vrid track admin-vrrp command unbinds a VRRP group from an mVRRP group.

By default, no VRRP group is bound to an mVRRP group.


vrrp vrid virtual-router-id1 track admin-vrrp interface interface-type interface-number vrid virtual-router-id2 unflowdown

undo vrrp vrid virtual-router-id1 track admin-vrrp


Parameter Description Value
vrid virtual-router-id1 Specifies the VRID of a VRRP group. The value is an integer that ranges from 1 to 255.
vrid virtual-router-id2 Specifies the VRID of an mVRRP group. The value is an integer that ranges from 1 to 255.
interface-type interface-number Specifies the type and number of the interface configured with an mVRRP group.
  • interface-type specifies the interface type.
  • interface-number specifies the interface number.

Allows the interface where a VRRP group bound to an mVRRP group is configured to retain the Up state if the mVRRP group is in Backup or Initialize state.



VLANIF interface view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

If multiple VRRP groups are configured on the device, each group sends VRRP Advertisement packets to maintain its state machine. A large number of VRRP Advertisement packets are generated, which occupy network bandwidth resources and cause CPU performance to deteriorate. To solve the problem, run the vrrp vrid track admin-vrrp vrid command to bind a VRRP group to an mVRRP group. After a VRRP group is bound to an mVRRP group, the VRRP group does not send VRRP Advertisement packets to negotiate the Master and Backup states. The mVRRP group determines the status of the bound VRRP group. This method greatly reduces the impact of VRRP Advertisement packets on network bandwidth and CPU performance.

This mode is used on a network where uplink and downlink traffic can be transmitted along different paths. unflowdown can be configured to allow the mVRRP group to determine the status of its bound VRRP group. Uplink traffic travels through the master and then reaches the upper-layer network, and downlink traffic travels through either the master or backup and reaches a user.


A VRRP group and an mVRRP group have been created.

The vrrp vrid track admin-vrrp vrid command can be used only on the interface where the bound VRRP group is configured. It cannot be used on the interface where an mVRRP group is configured.


# Bind VRRP group 1 to mVRRP group 2.

<Huawei> system-view
[Huawei] interface vlanif 10
[Huawei-Vlanif10] vrrp vrid 1 track admin-vrrp interface vlanif 20 vrid 2 unflowdown
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 202222

Downloads: 122

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next