No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).



The cca-threshold command sets the clear channel assessment (CCA) threshold for APs.

The undo cca-threshold command restores the default CCA threshold of APs.

By default, no CCA threshold is specified. APs use the default CCA threshold of the chip.


cca-threshold cca-threshold

undo cca-threshold


Parameter Description Value

Specifies the CCA threshold for APs.

The value is an integer that ranges from -85 to -40, in dBm.


2G radio profile view, 5G radio profile view

Default Level

2: Configuration level

Usage Guidelines

The CCA mechanism enables a WLAN chip to determine whether the channel is idle before transmitting signals to the air interface. If so, the chip transmits signals. If not, the chip waits until the channel is idle.

The CCA threshold is used by a WLAN chip to determine whether the channel is idle. If the noise on the channel exceeds the threshold, the chip considers the channel busy. Otherwise, the chip considers the channel idle.

When deploying a WLAN, set a proper CCA threshold to reduce signal interference and improve the channel reuse rate.
  • If APs densely are deployed, a high CCA threshold is recommended to narrow down the coverage and skip remote weak signals.
  • If APs are sparsely deployed, a low CCA threshold is recommended to maximize the effective coverage of signals.


# Set the CCA threshold for a 2G radio to -70 dBm.

<Huawei> system-view
[Huawei] wlan
[Huawei-wlan-view] radio-2g-profile name default
[Huawei-wlan-radio-2g-prof-default] cca-threshold -70
Warning: This parameter may affect uplink access coverage or STA access. Modify this parameter only under the guidance of technical
personnel. Continue? [Y/N]Y
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 211901

Downloads: 122

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next