No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ntp-service unicast-server

ntp-service unicast-server

Function

The ntp-service unicast-server command configures the NTP unicast server/client mode.

The undo ntp-service unicast-server command cancels the NTP unicast server/client mode.

By default, the NTP server mode is not configured.

Format

ntp-service unicast-server ip-address [ version number | authentication-keyid key-id | maxpoll max-number | minpoll min-number | source-interface interface-type interface-number | preference ] *

undo ntp-service unicast-server ip-address

Parameters

Parameter Description Value
ip-address Indicates the IPv4 address of the remote server. The parameter ip-address is a host address and cannot be the broadcast address, the multicast address or the IP address of a reference clock.
version number Indicates the NTP version number. If this parameter is not specified, the default version number is used. Version number is an integer and ranges from 1 to 4. By default, the version number is 3.
authentication-keyid key-id Indicates the authentication key number used when messages are transmitted to the remote server. If this parameter is not specified, authentication is not performed.

Key ID is an integer and ranges from 1 to 4294967295.

maxpoll max-number Specifies the NTP maximum poll interval. The NTP poll interval of the system floats between the minimum value and maximum value.

It is an integer ranging from 10 to 17, in seconds. The default value is 10 seconds in NTPv1, NTPv2, NTPv3, and NTPv4.

minpoll min-number

Specifies NTP minimum poll interval. The NTP poll interval of the system floats between the minimum value and maximum value.

It is an integer ranging from 3 to 6, in seconds. The default value is 6 seconds.

source-interface interface-type interface-number Indicates the source interface from which the unicast client sends NTP packets to the unicast server. The source IP address of the NTP packets is the IP address of this interface.

-

preference Indicates the remote server as the preferred one. By default, the remote server is not preferred. -

Views

System view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

When the clock of a device on the network needs to be synchronized in unicast server/client mode, the command can be run, and the remote server specified by ip-address is used as the local clock server. The local device runs in client mode. In this mode, the local client can be synchronized to the remote server, but the remote server cannot be synchronized to the local client.

Example

# Configure the server 10.10.1.1 to provide the synchronizing time for the local device. The NTP version number is 3.

<Huawei> system-view
[Huawei] ntp-service unicast-server 10.10.1.1 version 3
Translation
Download
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 212787

Downloads: 122

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next