No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
stp point-to-point

stp point-to-point


The stp point-to-point command sets the link type of a port.

The undo stp point-to-point command restores the default link type.

By default, the link type of the ports on the switching device is auto. That is, the spanning tree protocol detects whether a port is connected to a P2P link.


stp point-to-point { auto | force-false | force-true }

undo stp point-to-point


Parameter Description Value
force-true Indicates the link type is P2P. -
force-false Indicates the link type is non-P2P. -
auto Indicates that the spanning tree protocol detects automatically whether the port is connected to a P2P link. -


GE interface view, Eth-Trunk interface view, XGE interface view, MultiGE interface view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

On a Layer 2 network running a spanning tree protocol, if a port of a switching device is connected to a non-P2P link, the port cannot perform fast status transition.

If a port works in full-duplex mode, the port is connected to a P2P link, and force-true can be set in the stp point-to-point command.

If a port works in half-duplex mode, the stp point-to-point force-true command can be used to forcibly set the type of the link to which the port is connected to P2P, implementing rapid network convergence.


The stp point-to-point command configuration on a port takes effect in all spanning tree instances where the port resides.


# Set the link type of GE0/0/1 as P2P.
<Huawei> system-view
[Huawei] interface gigabitethernet 0/0/1
[Huawei-GigabitEthernet0/0/1] stp point-to-point force-true
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 209242

Downloads: 122

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next