No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Fat AP and Cloud AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
sta-load-balance dynamic sta-number start-threshold

sta-load-balance dynamic sta-number start-threshold

Function

The sta-load-balance dynamic sta-number start-threshold command sets the start threshold for dynamic load balancing based on the number of users.

The undo sta-load-balance dynamic sta-number start-threshold command restores the default start threshold for dynamic load balancing based on the number of users.

By default, the start threshold for dynamic load balancing based on the number of users is 10.

Only cloud APs support this command.

Format

sta-load-balance dynamic sta-number start-threshold start-threshold

undo sta-load-balance dynamic sta-number start-threshold

Parameters

Parameter

Description

Value

start-threshold start-threshold

Specifies the start threshold for dynamic load balancing based on the number of users.

The value is an integer that ranges from 1 to 40.

Views

RRM profile view

Default Level

2: Configuration level

Usage Guidelines

When a user requests to connect to an AP, the AP counts the total number of access users on all radios. If the number of access users on the requested radio does not exceed the start threshold, the AP does not implement dynamic load balancing based on the number of users. The AP implements dynamic load balancing based on the number of users only after the number of access users exceeds the start threshold.

The start and load difference thresholds for dynamic load balancing configured using the sta-load-balance dynamic sta-number gap-threshold command can be used to adjust sensitivity for triggering load balancing. The default values are recommended in typical scenarios. A higher threshold is recommended in high-density scenarios. If the start and load difference thresholds are set low, load balancing becomes far easier to be triggered. As a result, STAs are frequently switched between APs, affecting user experience. If the start and load difference thresholds are set high, the load balancing mechanism may become invalid.

Example

# Set the start threshold for dynamic load balancing based on the number of users to 20 in RRM profile default.

<Huawei> system-view
[Huawei] wlan
[Huawei-wlan-view] rrm-profile name default
[Huawei-wlan-rrm-prof-default] sta-load-balance dynamic sta-number start-threshold 20
Translation
Download
Updated: 2019-11-21

Document ID: EDOC1100064352

Views: 202341

Downloads: 122

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next