No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fit AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
reset factory-configuration

reset factory-configuration


The reset factory-configuration command restarts a device and restores the factory settings of the device.


reset factory-configuration




User view

Default Level

3: Management level

Usage Guidelines

Usage Scenario

If the device cannot work properly due to incorrect configurations, you can run the reset factory-configuration command to restart the device and restore the factory settings.


When an upstream device is connected to a central AP or an AP with two network ports through an Eth-Trunk, you need to enable one member interface of the Eth-Trunk and disable other member interfaces before restoring the factory settings of the AP by holding down Default, or running the reset factory-configuration command in the AC's WLAN view. Otherwise, loops and MAC address flapping occur, and the network connection fails.


# Restore the factory settings of the device.

<Huawei> reset factory-configuration
Warning: All of configurations will restore to factory and restart, Are you sure
 to continue? [y/n]: y
Updated: 2019-07-18

Document ID: EDOC1100064353

Views: 151778

Downloads: 125

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next