No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Fit AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
display interface vlanif

display interface vlanif

Function

The display interface vlanif command displays the status and configuration of a VLANIF interface.

Format

display interface vlanif [ vlan-id | main ]

Parameters

Parameter

Description

Value

vlan-id

Specifies the ID of a VLAN.

The value is an integer and the value range depends on the range of existing VLANIF interfaces. You can enter the question mark (?) to obtain the range of VLAN IDs.

main

Displays status and traffic statistics about a VLANIF interface.

A VLANIF interface has no sub-interfaces. Status and traffic statistics about a VLANIF interface are displayed whether you specify the main parameter or not.

-

Views

All views

Default Level

1: Monitoring level

Usage Guidelines

Usage Scenario

To monitor an interface or locate an interface fault, you can use the display interface vlanif command to view the interface status, interface configuration, and traffic statistics on the interface.

Prerequisites

The specified VLANIF interface has been created.

Precautions

If vlan-id is not specified, the display interface vlanif command displays information about all VLANIF interfaces in the system.

Example

# Display the status and configuration of VLANIF 3.

<Huawei> display interface vlanif 3
Vlanif3 current state : DOWN
Line protocol current state : DOWN
Description:HUAWEI, AP Series, Vlanif3 Interface
Route Port,The Maximum Transmit Unit is 1500
Internet protocol processing : disabled
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 00e0-fc01-00e1
Current system time: 2007-09-12 20:21:13
    Input bandwidth utilization  : --
    Output bandwidth utilization : --
Table 6-9  Description of the display interface vlanif command output

Item

Description

current state

Status of a VLANIF interface. The value is UP or Down.

Line protocol current state

Status of the link-layer protocol on a VLANIF interface. The value is UP or Down.

Last line protocol up time

The last time the line protocol is up.

Description

Description of a VLANIF interface.

Route Port

Indicates that the interface is a Layer 3 interface.

The Maximum Transmit Unit

Specifies the MTU of a VLANIF interface.

Internet Address

IP address of a VLANIF interface. If the VLANIF interface does not have an IP address, the system displays "Internet protocol processing: disabled."

IP Sending Frames' Format

Encapsulation format of IP packets, which can be PKTFMT_ETHNT_2, Ethernet_802.3, or Ethernet_SNAP.

Hardware address

MAC address of the VLANIF interface.

Current system time

Indicates the current system time.

If the system is configured with a time zone and is in the summer time, the time is displayed in the format of YYYY/MM/DD HH:MM:SS UTC±HH:MM DST.

Input/Output bandwidth utilization

Inbound/outbound bandwidth utilization on an interface.

Translation
Download
Updated: 2019-07-18

Document ID: EDOC1100064353

Views: 131709

Downloads: 105

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next