No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fit AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ap-address static ac-list

ap-address static ac-list


The ap-address static ac-list command configures the AC list for APs.

The undo ap-address static ac-list command deletes the configured AC address list on APs.

By default, no AC list is configured.


ap-address static ac-list ip-address &<1-4>

undo ap-address static ac-list


Parameter Description Value
ip-address Specifies the IP address for an AC. The value is in dotted decimal notation.


System view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

You can run the ap-address static ac-list command to configure the AC list on an AP. After going online, the AP sends unicast discovery packets to the AC address to locate the AC.

Follow-up Procedure

You must run the reboot command to restart the AP to make the configuration take effect.


# Configure the AC address on the AP to

<Huawei> system-view
[Huawei] ap-address static ac-list
Updated: 2019-07-18

Document ID: EDOC1100064353

Views: 133474

Downloads: 106

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next