No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Fit AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
loopback

loopback

Function

The loopback command enables loopback detection on an interface.

The undo loopback command disables loopback detection on an interface.

By default, loopback detection is not configured.

NOTE:

The AD9431DN-24X does not support this command.

Format

loopback remote

undo loopback

Parameters

Parameter

Description

Value

remote

Configures remote loopback detection on an interface.

-

Views

GE interface view, Ethernet interface view, MultiGE interface view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

Loopback detection can be enabled to test some special functions, for example, locating faults on the Ethernet. After loopback detection is enabled, the Ethernet interface works in full-duplex mode. After loopback detection is disabled, the original duplex mode of the Ethernet interface is restored.

After remote loopback detection is configured, the local interface sends a packet received from the peer interface back to the peer interface, rather than forwarding the packet to the destination address.

Follow-up Procedure

Use a dedicated test tool to check whether the number of packets received and the number of packets sent on the Ethernet interface are the same. If not, the hardware is faulty. If yes, the hardware works properly.

Precautions

Loopback detection interrupts the operation of Ethernet interfaces and links. After loopback detection is performed, run the undo loopback command to disable loopback detection immediately.

Example

# Configure remote loopback detection on GE0/0/1.
<Huawei> system-view
[Huawei] interface gigabitethernet 0/0/1
[Huawei-GigabitEthernet0/0/1] loopback remote
Info: This may interrupt the operation of Ethernet interfaces and links.Continue
? [Y/N]:y
Related Topics
Translation
Download
Updated: 2019-07-18

Document ID: EDOC1100064353

Views: 127762

Downloads: 98

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next