No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Fit AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ap-address static ip-address

ap-address static ip-address

Function

The ap-address static ip-address command configures the static IP address used by an AP to go online.

The undo ap-address static ip-address command deletes the static IP address used by an AP to go online.

By default, no static IP address is configured for an AP.

Format

ap-address static ip-address ip-address { mask | mask-length } [ gateway ]

undo ap-address static ip-address

Parameters

Parameter Description Value
ip-address Specifies the static IP address for an AP. The value is in dotted decimal notation.
mask Specifies the IP address mask for an AP. The value is in dotted decimal notation.
mask-length Specifies the IP address mask length for an AP. The value is an integer that ranges from 0 to 32.
gateway Specifies the egress gateway for AP routes. The value is in dotted decimal notation.

Views

System view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

You can run the ap-address static ip-address command to configure the static IP address used by an AP to go online.

Precautions

Ensure that there are reachable routes between the configured IP address and the AC source address for an AP to go online. Otherwise, the AP may fail to go online.

If the AP and AC are connected through a Layer-3 network, the egress gateway for AP routes must be configured.

Prerequisites

The AP has been configured to go online in static mode using the ap-address mode command.

Follow-up Procedure

You must run the reboot command to restart the AP to make the configuration take effect.

Example

# Set the static IP address to 192.168.10.254/24.

<Huawei> system-view
[Huawei] ap-address static ip-address 192.168.10.254 24 
Translation
Download
Updated: 2019-07-18

Document ID: EDOC1100064353

Views: 153146

Downloads: 125

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next