No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fit AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
display this ipv6 interface

display this ipv6 interface


The display this ipv6 interface command displays IPv6 information on the current interface.


display this ipv6 interface




VLANIF interface view, loopback interface view

Default Level

1: Monitoring level

Usage Guidelines

The display this ipv6 interface command must be run in the interface view.


# Display IPv6 information on VLANIF100.

<Huawei> system-view
[Huawei] interface vlanif 100
[Huawei-Vlanif100] display this ipv6 interface
Vlanif100 current state : UP                                                    
IPv6 protocol current state : UP                                                
IPv6 is enabled, link-local address is FE80::7254:F5FF:FEDF:9B40 [TENTATIVE]    
  Global unicast address(es):                                                   
    1:1::1:1, subnet is 1:1::/64 [TENTATIVE]                                    
  Joined group address(es):                                                     
  MTU is 1500 bytes                                                             
  ND DAD is enabled, number of DAD attempts: 1                                  
  ND reachable time is 30000 milliseconds                                       
  ND retransmit interval is 1000 milliseconds                                   
  Hosts use stateless autoconfig for addresses                                  
Table 6-61  Description of the display this ipv6 interface command output



Vlanif100 current state

Current physical status of VLANIF 100.

IPv6 protocol current state

Current protocol status of the interface.

link-local address

Link-local address configured on the interface.

Global unicast address(es)

Global unicast address configured on the interface.

Joined group address(es)

Addresses of all multicast groups that the interface joins.


MTU of the interface.

number of DAD attempts

Number of times duplicate address detection is performed.

ND reachable time

Neighbor reachable time.

ND retransmit interval

Retransmission interval.

Hosts use stateless autoconfig for addresses

Hosts obtain addresses using stateless autoconfiguration.

Updated: 2019-07-18

Document ID: EDOC1100064353

Views: 156474

Downloads: 127

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next