No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Fit AP V200R010C00 Command Reference

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
display interface ethernet brief

display interface ethernet brief

Function

The display interface ethernet brief command displays brief information about all Ethernet interfaces.

Format

display interface ethernet brief [ main ]

Parameters

Parameter

Description

Value

main

Displays brief information about all Ethernet main interfaces.

-

Views

All views

Default Level

1: Monitoring level

Usage Guidelines

Usage Scenario

You can use the display interface ethernet brief command to view brief information about Ethernet interfaces, including the physical status, auto-negotiation mode, duplex mode, bandwidth, and average inbound and outbound bandwidth usages within the last period of time. This information helps you locate and rectify faults.

Precautions

To clear statistics on an interface, run the reset counters interface command.

Example

# Display brief information about all Ethernet interfaces.

<Huawei> display interface ethernet brief
PHY: Physical                                                                   
*down: administratively down                                                    
(l): loopback                                                                   
InUti/OutUti: input utility/output utility                                      
Interface                   PHY   Auto-Neg Duplex Bandwidth  InUti OutUti Trunk 
GigabitEthernet0/0/1        up    enable   full       1000M  0.01%  0.01%    -- 
Table 5-8  Description of the display interface ethernet brief command output

Item

Description

Interface

Type and number of an interface. All interfaces are displayed in alphabetical order. Information about the following interfaces can be displayed:
  • GE interface

  • Ethernet interface

PHY

Physical status of an interface:
  • up: indicates that the interface works properly.

  • down: indicates that the physical layer of the interface fails.

  • *down: refers to Administratively Down, indicating that the administrator has run the shutdown (interface view) command on the interface.

  • (l): refers to loopback, indicating that the loopback function is enabled on the interface.

Auto-Neg

Whether auto-negotiation is enabled on an interface:
  • enable: indicates that auto-negotiation is enabled on the interface.

  • disable: indicates that auto-negotiation is disabled on the interface.

Duplex

Duplex mode of an interface:
  • full: indicates the full-duplex mode.

  • half: indicates the half-duplex mode.

Bandwidth

Bandwidth on the interface.

InUti

Average inbound bandwidth usage within the last 5 minutes.

Average inbound bandwidth usage = Average inbound rate within the last 5 minutes/Interface bandwidth

OutUti

Average outbound bandwidth usage within the last 5 minutes.

Average outbound bandwidth usage = Average outbound rate within the last 5 minutes/Interface bandwidth

Trunk

Number of the Eth-Trunk to which an interface is added.

Translation
Download
Updated: 2019-07-18

Document ID: EDOC1100064353

Views: 89848

Downloads: 61

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next