No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Fit AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ap-address static ip-address ipv6

ap-address static ip-address ipv6

Function

The ap-address static ip-address ipv6 command configures a static IPv6 address for an AP.

The undo ap-address static ip-address command deletes the configured static IPv6 address.

By default, no static IPv6 address is configured for an AP.

Format

ap-address static ip-address ipv6 { ipv6-address prefix-length | ipv6-address/prefix-length } [ gateway ]

undo ap-address static ip-address

Parameters

Parameter Description Value
ipv6-address Specifies a static IPv6 address for an AP. The value is a 32-digit hexadecimal number, in the format X:X:X:X:X:X:X:X.
prefix-length Specifies the prefix length of an IPv6 address. The value is an integer that ranges from is 1 to 128.
gateway Specifies the AP's egress gateway. The value is a 32-digit hexadecimal number, in the format X:X:X:X:X:X:X:X.

Views

System view

Default Level

2: Configuration level

Usage Guidelines

Use Scenario

You can run this command to configure static IPv6 addresses for APs.

Precautions

The route between the AP's IPv6 address and the AC's source IP address must be reachable; otherwise, the AP cannot go online on the AC.

If APs connect to the AC through a Layer 3 network, an egress gateway must be configured.

Prerequisites

APs have been configured to go online in static mode using the ap-address mode command.

Follow-up Procedure

Run the reboot command to restart the APs.

Example

# Configure the IPv6 address 2001:db8:2002::10 for the AP, set the prefix length of the IPv6 address to 64, and configure the gateway address as 2001:db8:2002::1.

<Huawei> system-view
[Huawei] ap-address static ip-address ipv6 2001:db8:2002::10/64 2001:db8:2002::1
Translation
Download
Updated: 2019-07-18

Document ID: EDOC1100064353

Views: 127557

Downloads: 98

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next