No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fit AP V200R010C00 Command Reference

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
display ipv6 interface

display ipv6 interface


The display ipv6 interface command displays IPv6 information on an interface.


display ipv6 interface [ interface-type interface-number | brief ]


Parameter Description Value
interface-type interface-number Displays IPv6 information on a specified interface.
  • interface-type specifies the interface type.
  • interface-number specifies the interface number.

If no interface is specified, IPv6 information on all interfaces configured with IPv6 addresses is displayed.

brief Displays brief information about the interface. -


All views

Default Level

1: Monitoring level

Usage Guidelines

Before running this command, ensure that the interface is configured with an IPv6 address. If no IPv6 address is assigned to the interface, no interface information is displayed.


# Display IPv6 information on VLANIF100.
<Huawei> display ipv6 interface vlanif 100
Vlanif100 current state : UP
IPv6 protocol current state : UP
IPv6 is enabled, link-local address is FE80::200:1FF:FE04:5D00 [TENTATIVE]
  Global unicast address(es):
    2001:db8:2002::1, subnet is 2001:db8:2001::/64 [TENTATIVE]
  Joined group address(es):
  MTU is 1500 bytes
  ND DAD is enabled, number of DAD attempts: 1
  ND reachable time is 30000 milliseconds
  ND retransmit interval is 1000 milliseconds
  Hosts use stateless autoconfig for addresses
Table 6-55  Description of the display ipv6 interface command output



IPv6 protocol current state

Current protocol status of the interface.

link-local address

Link-local address configured on the interface.

Global unicast address(es)

Global unicast address configured on the interface.

Joined group address(es)

Addresses of all multicast groups that the interface joins.


MTU of the interface.

ND DAD is enabled

NS packets are sent when the system performs Duplicate Address Detection (DAD).

number of DAD attempts

Number of times duplicate address detection is performed.

ND reachable time

Neighbor reachable time.

ND retransmit interval

Retransmission interval.

Hosts use stateless autoconfig for addresses

Hosts obtain IPv6 addresses using stateless autoconfiguration.

Updated: 2019-07-18

Document ID: EDOC1100064353

Views: 131453

Downloads: 105

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next