No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Configuration Guide - Basic Configuration

This document describes the configurations of Basic, including CLI Overview, EasyDeploy Configuration, USB-based Deployment Configuration, Logging In to a Device for the First Time, CLI Login Configuration, Web System Login Configuration, File Management, Configuring System Startup, ISSU Configuration, BootLoad Menu Operation.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Configuration

Verifying the Configuration


  • Run the display issu timer rollback command in the user view to check the value of the ISSU rollback timer and remaining time.
  • Run the display issu module command in the user view to check the service modules that support ISSU.
  • Run the display issu check-result command in the user view to view the ISSU check result.
  • Run the display issu backup state command in the user view to check the status of data backup between the new master MPU and old master MPU.
  • Run the display issu backup-result [ state { resource-prepare | backup-prepare | backup1 | backup2 | backup3 | smooth | smooth-all-over } ] command in the user view to check the ISSU backup result.
  • Run the display issu recover-configuration command in the user view to check the commands of which the configurations fail to be restored.
  • Run the display issu switch-result { check | prepare | age } command in the user view to check the ISSU switchover result and switchover failure cause.
  • Run the display issu state command in the user view to check the current ISSU phase.
Updated: 2019-04-08

Document ID: EDOC1100065643

Views: 11824

Downloads: 41

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next