No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Configuration Guide - QoS

This document describes the configurations of QoS functions, including MQC, priority mapping, traffic policing, traffic shaping, interface-based rate limiting, congestion avoidance, congestion management, packet filtering, redirection, traffic statistics, ACL-based simplified traffic policy, and HQoS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Applying a DiffServ Domain

Applying a DiffServ Domain


You can bind a DiffServ domain to an inbound or outbound interface of packets to enable the device to implement mapping between packet priorities and PHBs/colors according to the mappings defined in the DiffServ domain.


  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run trust upstream { ds-domain-name | default | none }

    A DiffServ domain is bound to the interface.

    If trust upstream none is configured on an interface, the system does not perform priority mapping for incoming and outgoing packets.

    To change the DiffServ domain bound to an interface, run the undo trust upstream command to unbind the original DiffServ domain from the interface, and then run the trust upstream command to bind a new DiffServ domain to the interface.

  4. (Optional) Run undo qos phb marking enable

    PHB mapping is disabled for outgoing packets.

    By default, PHB mapping is enabled for outgoing packets on an interface.

Updated: 2019-04-08

Document ID: EDOC1100065653

Views: 18921

Downloads: 45

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next