No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Configuration Guide - Reliability

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, NSR Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Association Between VRRP6 and the Interface Status to Implement an Active/Standby Switchover

Configuring Association Between VRRP6 and the Interface Status to Implement an Active/Standby Switchover

Context

When the uplink interface of the master becomes faulty, VRRP6 cannot detect the status change of interfaces not in the VRRP6 group, causing service interruption. You can associate a VRRP6 group with the interface status. When the monitored interface is faulty, the priority of the master is reduced. This triggers an active/standby switchover and reduces the impact of the uplink interface fault on service forwarding.

When the fault is rectified, the original master restores its priority and becomes the master again to forward traffic.

NOTE:

The master and backup in the VRRP6 group must work in preemption mode. It is recommended that the preemption delay be 0 on the backup and non-zero on the master.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The view of the interface on the master where a VRRP6 group is configured is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run vrrp6 vrid virtual-router-id track interface interface-type interface-number [ increased value-increased | reduced value-reduced ]

    Association between VRRP6 and the interface status is configured.

    NOTE:

    If the IPv4 protocol status on the monitored interface configured with an IPv4 address changes, the priority of the master is reduced. If the IPv6 protocol status on the monitored interface configured with an IPv6 address changes, the VRRP6 group remains unchanged.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100065654

Views: 28553

Downloads: 29

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next