No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Configuration Guide - Reliability

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, NSR Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Summary of Smart Link and Monitor Link Configuration Tasks

Summary of Smart Link and Monitor Link Configuration Tasks

The switch supports the following Smart Link and Monitor Link features: basic functions of Smart Link, load balancing, link switching notification to the VPLS/VLL module, and basic functions of Monitor Link.

Table 6-2 describes the Smart Link and Monitor Link configuration tasks.

Table 6-2  Smart Link and Monitor Link configuration tasks




Configure basic functions of Smart Link

Basic functions of Smart Link can be configured to implement active/standby link redundancy and switching, improving network reliability.

Configuring Basic Functions of Smart Link

Configure load balancing in a Smart Link group

Load balancing improves link efficiency.

Configuring Load Balancing in a Smart Link Group

Configure Smart Link to notify the VPLS/VLL module of link switching events

When Smart Link is used in VPLS or VLL networking, the link switching notification function enables the VPLS/VLL module to quickly detect link switching events, which minimizes data loss.

Configuring Smart Link to Notify the VPLS/VLL Module of Link Switching Events

Configure Monitor Link

Monitor Link monitors an uplink interface on a device and triggers Up/Down state transitions on downlink interfaces in accordance with state changes on the uplink interface. State transitions on the downlink interfaces then trigger link switching of the topology protocol on the downstream device.

Configuring the Uplink and Downlink Interfaces in a Monitor Link Group

Updated: 2019-04-08

Document ID: EDOC1100065654

Views: 32609

Downloads: 29

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next