No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Configuration Guide - Reliability

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, NSR Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Association Between VRRP and Routing to Monitor the Uplink Status

Configuring Association Between VRRP and Routing to Monitor the Uplink Status


VRRP cannot detect faults on the uplink of a VRRP group, which may cause service interruption. The VRRP group monitors the number of routes on the uplink forwarding path. When the route is withdrawn or becomes inactive, the master's priority is adjusted and an active/standby switchover is triggered. This reduces the impact of the link fault on service forwarding.

When the fault is rectified, the original master restores its priority and becomes the master again to forward traffic.

During route association, the link switchover depends on convergence of a routing protocol associated with the VRRP group.

  • When a VRRP group is associated with a static route, the device can detect only faults on the direct uplink.

  • The master and backup in the VRRP group must work in preemption mode. It is recommended that the preemption delay be 0 on the backup and non-zero on the master.


  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The view of the interface on the master where a VRRP group is configured is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run vrrp vrid virtual-router-id track ip route ip-address { mask-address | mask-length } [ vpn-instance vpn-instance-name ] [ reduced value-reduced ]

    Association between a route and a VRRP group is configured.

    By default, the master's priority decreases by 10 if the associated route is withdrawn or becomes inactive.

    When setting the value by which the priority decreases, ensure that the priority of the backup is higher than the priority of the master.

Updated: 2019-04-08

Document ID: EDOC1100065654

Views: 31849

Downloads: 29

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next