No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Configuration Guide - Reliability

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, NSR Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Overview of Smart Link and Monitor Link

Overview of Smart Link and Monitor Link


Smart Link is a link backup feature that implements fast switchover between two interfaces, one of which acts as a backup of the other. The Smart Link feature is used on dual-homed networks to provide effective link backup and fast switchover.

Monitor Link is an interface association mechanism that monitors the uplink interface in a Monitor Link group and sets the downlink interface states accordingly. In the event of a failure on the uplink interface, Monitor Link shuts down the associated downlink interface, so that the topology protocol on the downstream device triggers a link switchover.


When a device connects to an upstream device through a single uplink, a single-point failure will result in service interruption. In a dual-homed network, a downstream device is connected to two upstream devices to reduce the impact of single-point failures, thereby improving network reliability. Figure 6-1 shows a dual-homed network.

Figure 6-1  Dual-homed network

As shown in Figure 6-1, SwitchA is dual homed to SwitchB and SwitchC. Therefore, two links are available from SwitchA to SwitchD: SwitchA -> SwitchB -> SwitchD and SwitchA -> SwitchC -> SwitchD. Ring networking, however, is prone to network storms. Smart Link can be configured on SwitchA to solve this problem. When the link on Interface1 is working normally, the link on Interface2 functions as a backup link and is blocked. If the link on Interface1 fails, Smart Link automatically switches data traffic to the link on Interface2 to ensure service continuity.

Smart Link delivers the following benefits on a dual-homed network:
  • When both uplinks are running normally, one link is in forwarding state (active) and the other is in blocking state (inactive), preventing packet looping on the network.
  • Smart Link is easy to configure and use.
  • If the active link fails, traffic is switched to the standby link in milliseconds to ensure continued data forwarding and minimal packet loss.

Some Layer 2 topology protocols (such as Smart Link) cannot monitor the uplink interface states. As a result, these protocols cannot trigger a link switchover when an uplink becomes Down. Monitor Link monitors an uplink interface's state and changes the downlink interface state accordingly. If the uplink fails, Monitor Link shuts down the associated downlink interface. The topology protocol on the downstream device then triggers a link switchover, thereby reducing packet loss.

Updated: 2019-04-08

Document ID: EDOC1100065654

Views: 32899

Downloads: 29

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next