No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Configuration Guide - Reliability

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, NSR Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Load Balancing in a Smart Link Group

Configuring Load Balancing in a Smart Link Group

Pre-configuration Tasks

Load balancing between the links in a Smart Link group can improve link efficiency.

Before configuring load balancing in a Smart Link group, configure basic functions of Smart Link.


Usually, the standby link in a Smart Link group is idle and does not forward data traffic. To improve link utilization in a Smart Link group, you can configure a load balancing instance for the Smart Link group. Then the standby link transmits traffic of the VLANs mapped to the load balancing instance, and the active link transmits traffic of other VLANs. As the active and standby links transmit data traffic of different VLANs, traffic is shared between the two links.


  1. Run system-view

    The system view is displayed.

  2. Run stp region-configuration

    The MTS region view is displayed.

  3. Run instance instance-id vlan { vlan-id1 [ to vlan-id2 ] }&<1-10>

    The mapping between an instance and VLANs is configured.

    Instance 0 is the default instance and does not need to be created.

    By default, all VLANs are mapped to instance 0.


    To configure the mapping between an instance and MUX VLAN, map the principal VLAN, and subordinate group VLANs and subordinate separate VLANs of the MUX VLAN to the same instance. Otherwise, loops will occur.

  4. Run active region-configuration

    The MTS region configuration is activated.

    The configured MST region name, VLAN mapping table, and MSTP revision level take effect only after the active region-configuration command is executed.

  5. Run quit

    Return to the system view.

  6. Run smart-link group group-id

    The Smart Link group view is displayed.

  7. Run load-balance instance { instance-id1 [ to instance-id2 ] } &<1-10> slave

    The load balancing instance is specified for the Smart Link group. This ensures that traffic of the VLANs mapped to the instance is transmitted through the standby interface to implement load balancing.


    The load balancing instance specified by the load-balance instance command must be in the protected instance list configured by the protected-vlan reference-instance command.

Verifying the Configuration

Run the display smart-link group { all | group-id } command to verify information about the Smart Link group.

Updated: 2019-04-08

Document ID: EDOC1100065654

Views: 37350

Downloads: 31

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next