No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Configuration Guide - Reliability

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, NSR Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Delay Before a BFD Session Becomes Up

Setting the Delay Before a BFD Session Becomes Up


In practice, some devices determine whether to switch traffic based on the BFD session status. Because the routing protocol becomes Up after the interface becomes Up, routes will be not found when services are switched back, causing traffic loss. Therefore, the interval between the time when the routing protocol becomes Up and the time when the interface becomes Up must be eliminated.


  1. Run system-view

    The system view is displayed.

  2. Run bfd

    Global BFD is enabled and the BFD view is displayed.

  3. Run delay-up time

    A delay before a BFD session is set.

    By default, the delay before a BFD session becomes Up is 0.

Updated: 2019-04-08

Document ID: EDOC1100065654

Views: 28802

Downloads: 29

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next