No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Configuration Guide - Reliability

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, NSR Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Cascading of Smart Link and Monitor Link

Cascading of Smart Link and Monitor Link

Figure 6-14 shows cascading of Smart Link and Monitor Link, in which a Smart Link group can function as the uplink interface of a Monitor Link group. This networking provides enhanced reliability in link backup.

Figure 6-14  Cascading of Smart Link and Monitor Link

In Figure 6-14, the uplink interfaces on SwitchC and SwitchJ are added to Smart Link groups to guarantee reliability. Monitor Link groups are configured on SwitchC and SwitchJ, with the Smart Link groups serving as uplink interfaces. An active/standby switchover will be triggered on SwitchF only if both the two uplink interfaces in a Smart Link group are Down.

Table 6-1 lists the Smart Link and Monitor Link configuration on the switches.
Table 6-1  Configuration of Smart Link and Monitor Link

Smart Link Group

Monitor Link Group

Master Interface

Slave Interface

Uplink Interface

Downlink Interface


Interface C2

Interface C3

Smart Link group

Interface C2, Interface C3

Interface C1


Interface J2

Interface J3

Smart Link group

Interface J2, Interface J3

Interface J1


Interface F1

Interface F2

No Monitor Link group configured

Updated: 2019-04-08

Document ID: EDOC1100065654

Views: 29296

Downloads: 29

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next