No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Configuration Guide - Reliability

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, NSR Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, MAC Swap Loopback Configuration, EFM Configuration, CFM Configuration, Y.1731 Configuration.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Unidirectional Link Detection When Multiple Neighbors Exist

Unidirectional Link Detection When Multiple Neighbors Exist

DLDP can be configured for devices connected by hubs to detect unidirectional links. Each interface detects at least one neighbor.

As shown in Figure 5-7, a hub connects SwitchA to SwitchB, SwitchC, and SwitchD through copper twisted pairs or optical fibers. All switches support DLDP. To detect unidirectional links on this network, enable DLDP on all switch interfaces connected to the hub.

Figure 5-7  Networking diagram of multiple neighbors

On a network with multiple neighbors, an interface immediately enters the Disable state when receiving Disable packets from a neighbor or detecting that a neighbor is unidirectional. When SwitchA, SwitchB, and SwitchC detect a unidirectional link fault on SwitchD, they transition to the Disable state. This prevents traffic forwarding errors when the topology changes. If the Rx optical fiber between SwitchB and the hub is disconnected when SwitchA is forwarding traffic to SwitchB, SwitchA shuts down its interface connected to the hub and stops sending packets to SwitchB, SwitchC, and SwitchD. If a backup link exists between SwitchA and SwitchB, STP immediately starts the backup link when SwitchA shuts down the interface.

If the switches on the preceding network are connected by a device that has DLDP disabled but supports DLDPDU forwarding, DLDP still detects unidirectional links as if the network has multiple neighbors.

Updated: 2019-04-08

Document ID: EDOC1100065654

Views: 37119

Downloads: 31

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next