No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
smart-roam disable

smart-roam disable

Function

The smart-roam disable command disables smart roaming.

The undo smart-roam disable command enables smart roaming.

By default, smart roaming is enabled.

Format

smart-roam disable

undo smart-roam disable

Parameters

None

Views

RRM profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

On a traditional WLAN, when a STA is farther from an AP, the access rate of the STA becomes lower but the STA still associates with the AP without reconnecting the AP or roaming to another AP. This degrades user experience. After the smart roaming function is enabled, when an AP detects that the SNR or access rate of a STA is lower than the specified threshold, the AP sends a BTM packet or Disassociation packet to the STA. The STA then reconnects to the network or roams to an AP with stronger signals.

Follow-up Procedure

Run the smart-roam roam-threshold { check-snr | check-rate } command to configure the trigger mode of smart roaming and the smart-roam roam-threshold { snr | rate } command to configure the smart roaming threshold. After that, APs forcibly disconnect STAs with SNR or access rate lower than the threshold.

Example

# Enable smart roaming.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] rrm-profile name huawei
[HUAWEI-wlan-rrm-prof-huawei] undo smart-roam disable
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 112815

Downloads: 83

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next