No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
client-mode enable

client-mode enable


The client-mode enable command enables the Mesh client mode.

The undo client-mode enable command disables the Mesh client mode.

By default, the Mesh client mode is disabled.


client-mode enable

undo client-mode enable




Mesh profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

If the Mesh client is enabled for vehicle-mounted APs, trackside APs must also have the Mesh client enabled to set up a Mesh link.


You cannot configure the Mesh client mode and bind the Mesh profile to a Mesh handover profile at the same time.


# Enable the Mesh client mode for Mesh profile test.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] mesh-profile name test
[HUAWEI-wlan-mesh-prof-test] client-mode enable
Related Topics
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 115478

Downloads: 83

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next