No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
display station assoc-info ap-offline-record

display station assoc-info ap-offline-record

Function

The display station assoc-info ap-offline-record command displays information about STAs that connect to the APs in fault state.

Format

display station assoc-info ap-offline-record { all | { ap-name ap-name | ap-id ap-id } [ radio radio-id ] }

Parameters

Parameter

Description

Value

all

Displays information about STAs that connect to all APs in fault state.

-

ap-name ap-name

Displays information about STAs that go online on the AP with a specified name in fault state.

The AP name must exist.

ap-id ap-id

Displays information about STAs that go online on the AP with a specified ID in fault state.

The AP ID must exist.

radio radio-id

Displays information about STAs that connect to a specified radio of an AP in fault state.

The radio ID must exist.

Views

All views

Default Level

1: Monitoring level

Usage Guidelines

Usage Scenario

When link faults occur between the APs and AC, the APs in fault state allow access of new STAs and log the STA information. When the link between the APs and AC is re-established, the APs disconnect these STAs and send the STA information to the AC. You can run the display station assoc-info ap-offline-record command on the AC to check information about the STAs that connect to the APs in fault state.

Prerequisite

The APs in fault state have been enabled to allow access of new STAs using the keep-service enable allow new-access command.

Example

# Display information about STAs that connect to all APs in fault state.

<HUAWEI> display station assoc-info ap-offline-record all
Offline Station information list: 
------------------------------------------------------------------------------
STA MAC          AP name   RADIO ID  SSID
------------------------------------------------------------------------------
286E-D488-B74F   Huawei    0         SSID_MYWLAN
------------------------------------------------------------------------------
Total: 1 
Table 11-88  Description of the display station assoc-info ap-offline-record command output

Item

Description

STA MAC

MAC address of a STA.

AP name

Name of the AP that the STA connects to.

RADIO ID

ID of the radio that the STA connects to.

SSID

SSID that the STA connects to.

Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 115783

Downloads: 83

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next