No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
capwap source interface

capwap source interface

Function

The capwap source interface command configures the interface used by the AC to set up a CAPWAP tunnel as the AC's source interface.

The undo capwap source interface command disables the AC from using the interface to set up a CAPWAP tunnel as the source interface.

By default, the AC's source interface is not configured.

Format

capwap source interface { loopback loopback-number | vlanif vlan-id }

undo capwap source interface { loopback loopback-number | vlanif vlan-id }

Parameters

Parameter

Description

Value

loopback loopback-number

Configures a loopback interface as the source interface.

The value is an integer that ranges from 0 to 1023.

vlanif vlan-id

Configures a VLANIF interface as the source interface.

The value is an integer that ranges from 1 to 4094.

Views

System view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

An AC uses the IP address of the specified interface as the source IP address. All access devices connected to the AC can learn this IP address and use the IP address to communicate with the AC.

Prerequisites

An IP address has been assigned to the specified loopback or VLANIF interface.

Precautions

You can configure multiple source interfaces. The total number of source interfaces cannot exceed 8.

Only one source interface can be configured if the SVF function is enabled.

Configure multiple source interfaces. When the source interfaces are added to different VPN instances, the IP addresses of these interfaces cannot be the same.

When multiple source interfaces are configured, ensure that the management VLAN for APs is within the VLAN range mapping the source interfaces. Otherwise, APs cannot go online.

Changing configuration of the source interface will clear statistics of the CAPWAP packets in CPU attack defense.

Example

# Configure a loopback interface as the source interface.

<HUAWEI> system-view
[HUAWEI] interface loopback 20
[HUAWEI-LoopBack20] ip address 192.168.10.1 24
[HUAWEI-LoopBack20] quit
[HUAWEI] capwap source interface loopback 20
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 117266

Downloads: 83

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next