No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
station connectivity-detect disable

station connectivity-detect disable


The station connectivity-detect disable command disables STA connectivity check on the AP.

The undo station connectivity-detect disable command enables STA connectivity check on the AP.

By default, STA connectivity check is enabled on the AP.


station connectivity-detect disable

undo station connectivity-detect disable




AP system profile view

Default Level

2: Configuration level

Usage Guidelines

To locate network access faults of some STAs, the AP has STA connectivity check enabled by default. The AP randomly selects two of STAs that have associated with the AP for more than 20 seconds and encountered traffic exceptions (The STAs can obtain IP addresses and the default gateway, but has no uplink or downlink unicast traffic). The AP then detects network connectivity by pinging these two STAs and records the result in the log.

When STA connectivity is enabled, you can run the station connectivity-detect sta-mac mac-address command to specify a maximum of eight STAs for network connectivity check.


# Disable STA connectivity check.

<HUAWEI> system-view
[HUAWEI] wlan 
[HUAWEI-wlan-view] ap-system-profile name default
[HUAWEI-wlan-ap-system-prof-default] station connectivity-detect disable
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 126650

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next