No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
state block

state block


The state block command sets a WLAN work group in block state.

The undo state block command cancels the block state of a WLAN work group.

By default, a WLAN work group is not in block state.


state block

undo state block




WLAN work group

Default Level

2: Configuration level

Usage Guidelines

To prevent new users or APs from connecting to a WLAN work group, run this command to set the WLAN work group in block state. This command restarts or changes states of existing APs in the WLAN work group, causing them unable to go online.


# Set the WLAN work group in block state.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] wlan work-group 1
[HUAWEI-wlan-work-group1] state block
Warning: After the command is executed, new APs and users cannot access the network through this workgroup. Continue? [Y/N]: y
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 115614

Downloads: 83

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next