No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
sta-load-balance mode

sta-load-balance mode


The sta-load-balance mode command configures the dynamic load balancing mode.

The undo sta-load-balance mode command restores the default dynamic load balancing mode.

By default, dynamic load balancing based on the number of users is used.


sta-load-balance mode { sta-number | channel-utilization }

undo sta-load-balance mode






Controls user access based on the number of users.


Controls user access based on the channel usage.



RRM profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

You can run the sta-load-balance mode command to configure the dynamic load balancing mode based on the actual environment to provide better network experience for users.

  • Dynamic load balancing based on the channel usage uses a complex algorithm but is accurately implemented to ensure service quality. This mode is recommended when service types and traffic volumes differ greatly among users.
  • Dynamic load balancing based on the number of users is less accurate but uses a simple algorithm. This mode is recommended when most users have the same type of services and similar service traffic volumes.


When configuring RUs to load balance traffic based on the channel usage, run the ap data-collection enable command to enable the RU data buffering function on the central AP. If this function is disabled, dynamic load balancing based on the channel usage does not take effect.


# Configure dynamic load balancing based on the channel usage.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] rrm-profile name default
[HUAWEI-wlan-rrm-prof-default] sta-load-balance mode channel-utilization
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 126071

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next