No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
location source

location source

Function

The location source command configures a global source IP address in packets sent by an AC to a location server.

The undo location source command deletes a global source IP address from packets sent by an AC to a location server.

By default, the source IP address is not configured in packets sent by an AC to a location server.

Format

location source ip-address ip-address

undo location source

Parameters

Parameter

Description

Value

ip-address ip-address

Specifies a source IPv4 address in packets sent by an AC to a location server.

The value is in dotted decimal notation.

Views

WLAN view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

You can run the location source command to configure a source IP address in UDP packets sent by an AC to a location server.

Run the location source command to configure different source IP addresses for the active and standby ACs.

When source IP addresses are configured on an AC using the location source and source commands at the same time, the source IP address configured using the source command takes effect.

Precautions

  • Ensure that the AC IP address manually configured on the location server is the same as that configured using the location source command.
  • The source IP address must exist on the AC; otherwise, the configuration does not take effect.
  • In scenarios where Huawei proprietary terminal location protocols are used, an AC uses the source IP address of the CAPWAP tunnel to send packets to a location server. The source IP address specified by the location source command does not take effect.

Example

# Configure 10.102.25.23 as the source IP address of the UDP packets sent from the AC to the location server.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] location source ip-address 10.102.25.23
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 126893

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next