No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
sta-offline-delay aging-time

sta-offline-delay aging-time

Function

The sta-offline-delay aging-time command configures the aging time for STA offline delay.

The undo sta-offline-delay aging-time command restores the default aging time for STA offline delay.

The default aging time for STA offline delay is 180 seconds.

Format

sta-offline-delay aging-time time

undo sta-offline-delay aging-time

Parameters

Parameter

Description

Value

time

Specifies the aging time for STA offline delay.

The value is an integer that ranges from 1 to 86400, in seconds. The default value is 180.

Views

WLAN view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

After the STA offline delay function is enabled, STAs can go offline and online again in the aging time without being authenticated, reducing the load on the authentication server. You can run the sta-offline-delay aging-time command to set the aging time.

Set the aging time for STA offline delay based on the network requirements and device performance. A long aging time causes the STA offline delay function to occupy many resources, affecting new STA access. A short aging time cannot achieve a noticeable effect in releasing the load on the authentication server.

Prerequisites

The STA offline delay function has been enabled using the sta-offline-delay enable command.

Example

# Set the aging time for STA offline delay to 300s.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] sta-offline-delay enable
[HUAWEI-wlan-view] sta-offline-delay aging-time 300
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 113495

Downloads: 83

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next