No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).



The roaming-consortium-oi command configures the roaming consortium identifier of the Hotspot2.0 network.

The undo roaming-consortium-oi command deletes the roaming consortium identifier of the Hotspot2.0 network.

By default, no roaming consortium identifier is configured for the Hotspot2.0 network.


roaming-consortium-oi oi-value [ in-beacon ]

undo roaming-consortium-oi oi-value






Indicates the roaming consortium identifier, which is used to identify operators.

The format is HH-HH-HH or HH-HH-HH-HH-HH, in which H is in the hexadecimal format.


Indicates that the Beacon and probe-response frames sent by the AP contain the roaming consortium identifier.



Roaming consortium profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

If STAs may roam between the Hotspot2.0 network and a network of another operator, you can configure the OI of the operator that provides the roaming service so that STAs can select networks.


If you run this command multiple times, multiple OIs are configured. A maximum of 32 OIs can be configured in a roaming consortium profile. To configure OIs in the roaming consortium profile, the first OI must carry the in-beacon parameter. A maximum of three OIs can be configured to carry the in-beacon parameter.


# Add an OI 00-11-22 to the profile roaming-consortium-profile1 and add the OI to the Beacon and probe-response frames sent by the AP.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] roaming-consortium-profile name roaming-consortium-profile1
[HUAWEI-wlan-ro-co-prof-roaming-consortium-profile1] roaming-consortium-oi 00-11-22 in-beacon
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 123267

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next