No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
device report-interval

device report-interval

Function

The device report-interval command sets the interval at which an AP reports incremental wireless device information.

The undo device report-interval command restores the default interval at which an AP reports incremental wireless device information.

By default, an AP reports incremental wireless device information to an AC at an interval of 300 seconds.

Format

device report-interval interval

undo device report-interval

Parameters

Parameter

Description

Value

interval

Specifies the interval at which an AP reports incremental wireless device information.

The value is an integer that ranges from 10 to 3600, in seconds.

Views

WIDS profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

The monitoring AP buffers information about detected wireless devices at the interval set using the device report-interval command. When the interval is reached, the monitoring AP reports the information to the AC and then clear the reported information.

Prerequisites

The device detection function has been enabled using the wids device detect enable command for the AP.

Example

# Set the interval at which an AP reports incremental wireless device information to 120 seconds.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] ap-group name office
[HUAWEI-wlan-ap-group-office] radio 0
[HUAWEI-wlan-group-radio-office/0] wids device detect enable
[HUAWEI-wlan-group-radio-office/0] quit
[HUAWEI-wlan-ap-group-office] quit
[HUAWEI-wlan-view] wids-profile name office
[HUAWEI-wlan-wids-prof-office] device report-interval 120
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 113205

Downloads: 83

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next