No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).



The rate-limit command configures the rate limit for upstream and downstream packets of all STAs or each STA on a VAP.

The undo rate-limit command restores the default rate limit for upstream and downstream packets of all STAs or each STA on a VAP.

By default, the rate limit for upstream and downstream packets of all STAs on a VAP is 4294967295 kbit/s, and that of each STA is 4294967295 kbit/s.


rate-limit { client | vap } { up | down } rate-value

undo rate-limit { client | vap } { up | down }






Specifies a STA on a VAP.



Specifies all STAs on a VAP.



Specifies the rate limit for upstream packets on a VAP.



Specifies the rate limit for downstream packets on a VAP.



Specifies the limited rate of packets.

The value is an integer that ranges from 64 to 4294967295, in kbit/s.


Traffic profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

You can run the rate-limit command to limit the rate of upstream and downstream packets for all STAs or each STA on a VAP to protect network bandwidth resources.


The limited rate does not take effect for STAs that go online before the rate-limit command is configured. To make this configuration take effect for a STA, enable the STA to go online again.


# Set the limited rate of upstream packets to 4294967295 kbit/s for all STAs on a VAP in the traffic profile p1.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] traffic-profile name p1 
[HUAWEI-wlan-traffic-prof-p1] rate-limit vap up 4294967295
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 115538

Downloads: 83

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next