No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).



The radio-2g-profile command binds a 2G radio profile to a 2G radio.

The undo radio-2g-profile command unbinds a 2G radio profile from a 2G radio.

By default, no 2G radio profile is applied in the AP view and AP radio view, but the 2G radio profile default is applied to the AP group view and AP group radio view.


radio-2g-profile profile-name radio { radio-id | all }

undo radio-2g-profile radio { radio-id | all }

radio { radio-id | all } is supported only in the AP group view and AP view.






Specifies the name of a 2G radio profile.

The 2G radio profile must exist.

radio radio-id

Specifies a radio ID.

The value is an integer that is 0 and 2.

radio all

Specifies all radios.



AP group view, AP view, AP radio view, AP group radio view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

After you create a 2G radio profile using the radio-2g-profile (WLAN view) command, bind it to a 2G radio so that the 2G radio profile can take effect.


After a 2G radio profile is applied in the AP group view or AP view, the parameter settings in the profile take effect on all 2G radios in the AP group or the 2G radio of the AP.

The configuration in the AP view and AP radio view has a higher priority than that in the AP group view and AP group radio view.


# Create the 2G radio profile radio-profile1 and bind it to AP group group1.

<HUAWEI> system-view
[HUAWEI] wlan 
[HUAWEI-wlan-view] radio-2g-profile name radio-profile1
[HUAWEI-wlan-radio-2g-prof-radio-profile1] quit
[HUAWEI-wlan-view] ap-group name group1
[HUAWEI-wlan-ap-group-group1] radio-2g-profile radio-profile1 radio 0
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 127962

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next