No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ac protect protect-ac

ac protect protect-ac

Function

The ac protect protect-ac command configures the standby AC IP address in the WLAN view.

The undo ac protect protect-ac command restores the default standby AC IP address in the WLAN view.

By default, no standby AC IP address is configured in the WLAN view.

Format

ac protect protect-ac ip-address

undo ac protect protect-ac

Parameters

Parameter

Description

Value

ip-address

Specifies an IPv4 address for the standby AC.

The value is in dotted decimal notation.

Views

WLAN view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

To implement dual-link backup on all the APs connected to an AC, configure the AC priority and standby AC IP address in the WLAN view to reduce the configuration workload.

Precautions

If standby AC IP addresses are configured in both the WLAN view and AP system profile view before an AP goes online, the standby AC IP address configured in the AP system profile view is delivered to an AP. If no standby AC IP address is configured in the AP system profile view, the standby AC IP address configured in the WLAN view is delivered to an AP. If no standby AC IP address is configured in the WLAN view, dual-link backup is disabled.

Example

# Set the standby AC IP address to 10.33.12.56 in the WLAN view.

<HUAWEI> system-view
[HUAWEI] wlan 
[HUAWEI-wlan-view] ac protect protect-ac 10.33.12.56
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 116197

Downloads: 83

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next