No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
keep-service enable allow new-access

keep-service enable allow new-access

Function

The keep-service enable allow new-access command enables the APs in fault state to allow access of new STAs.

The undo keep-service enable command disables the APs in fault state from allowing access of new STAs.

By default, the APs in fault state are disabled from allowing access of new STAs.

Format

keep-service enable allow new-access [ no-auth ]

undo keep-service enable

Parameters

Parameter

Description

Value

no-auth

Allows access of STAs using Portal or MAC address authentication.

-

Views

AP system profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

The networks with low security requirements, which apply to hospitals or warehouses, require that the APs in fault state still allow access of new STAs when link faults occur between the APs and AC. After the keep-service enable allow new-access command is run, new STAs can still connect to the APs in fault state when the CAPWAP link between the APs and AC is disconnected.

Precautions

The command does not take effect on a WDS network.

After this command is executed, if the wids device detect enable and wids contain enable commands are configured to enable device detection and containment, the AP will continue providing data services after going offline. However, the AC considers the AP as a rogue or interference device and adds it to the containment list. The containment mechanism will disable the AP from allowing access of new STAs. Therefore, the function of enabling an offline AP to allow access of new STAs does not take effect in this case.

To enable an offline AP to allow access of new STAs using Portal or MAC address authentication, configure the no-auth parameter.

This function is applicable to scenarios where service data is forwarded in direct mode, the STA authentication mode is Portal, MAC address, open, WEP, or WPA/WPA2-PSK authentication.

Example

# Enable the APs in fault state to allow access of new STAs.

<HUAWEI> system-view
[HUAWEI] wlan 
[HUAWEI-wlan-view] ap-system-profile name ap-system1
[HUAWEI-wlan-ap-system-prof-ap-system1] keep-service enable allow new-access
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 113202

Downloads: 83

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next