No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ap lldp enable

ap lldp enable


The ap lldp enable command enables LLDP in the WLAN view.

The undo ap lldp enable command disables LLDP in the WLAN view.

By default, LLDP is enabled in the WLAN view.


ap lldp enable

undo ap lldp enable




WLAN view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

The Link Layer Discovery Protocol (LLDP) is a Layer 2 discovery protocol defined in the IEEE 802.1ab standard. Using LLDP, the AC or NMS can obtain Layer 2 information about the connected APs, including APs' interfaces and connections with other devices. Additionally, the AC or NMS can obtain details about network topology and interface changes. To view the Layer 2 link status between APs, and between APs and switch or analyze the network topology, enable WLAN LLDP.


WLAN LLDP can be enabled in the system view and the AP wired port link profile view.

  • An AP can send and receive LLDP packets only after LLDP is enabled in both the WLAN view and the AP wired port link profile view.
  • After LLDP is disabled in the WLAN view, the commands for enabling and disabling LLDP on the AP wired port link profile view do not take effect.


# Enable LLDP in the WLAN view.

<HUAWEI> system-view
[HUAWEI] wlan 
[HUAWEI-wlan-view] ap lldp enable
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 114637

Downloads: 83

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next