No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
primary-access

primary-access

Function

The primary-access command configures a primary AC IP address.

The undo primary-access command restores the default primary AC IP address.

By default, no primary AC IP address is configured.

Format

primary-access ip-address ip-address

undo primary-access

Parameters

Parameter

Description

Value

ip-address ip-address

Specifies an IPv4 address of the primary AC.

The value is in dotted decimal notation.

Views

AP system profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

In AC backup scenarios, a primary AC IP address is configured. When APs attempt to go online, they preferentially associate with the primary AC and establish CAPWAP tunnels.

Precautions

  • The configurations of primary-access and backup-access take effect only if both the commands are run to configure different IP addresses.
  • primary-access and backup-access cannot be configured with priority or protect-ac.
  • It is not recommended that primary-access and backup-access be configured with ac protect protect-ac or ac protect priority.
  • The configuration takes effect only after the AP is restarted.
  • The IP addresses specified by primary-access and backup-access must be configured the same as CAPWAP source IP addresses. If the CAPWAP source addresses have been translated using NAT, set the primary-access and backup-access IP addresses to the translated addresses.

Example

# Set the primary AC IP address to 10.33.12.56.

<HUAWEI> system-view
[HUAWEI] wlan 
[HUAWEI-wlan-view] ap-system-profile name sys1
[HUAWEI-wlan-ap-system-prof-sys1] primary-access ip-address 10.33.12.56
Translation
Download
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 115696

Downloads: 83

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next