No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
calibrate flexible-radio manual-recognize

calibrate flexible-radio manual-recognize


The calibrate flexible-radio manual-recognize command triggers identification of redundant radios.


calibrate flexible-radio manual-recognize




WLAN view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

The network administrator can run this command to manually trigger identification of redundant radios, and can enable DFA if discovering that redundant radios exist on the network.


Radio calibration has been enabled using the calibrate enable { auto [ interval interval-value [ start-time start-time ] ] | manual | schedule time time-value } command.


This command only triggers identification of redundant radios but does not switch or disable identified redundant radios.

Radio scanning is required for identifying redundant radios, which may degrade wireless service experience.

Follow-up Procedure

After redundant radios are identified, you can run the display flexible-radio status command to check the status of the redundant radios.


# Trigger identification of redundant radios.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] calibrate enable auto
[HUAWEI-wlan-view] calibrate flexible-radio manual-recognize
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 124754

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next