No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
interference co-channel threshold

interference co-channel threshold


The interference co-channel threshold command configures the alarm threshold for co-channel interference.

The undo interference co-channel threshold command restores the default alarm threshold for co-channel interference.

By default, the alarm threshold for co-channel interference is 50%.


interference co-channel threshold threshold-value

undo interference co-channel threshold






Specifies the alarm threshold, which is the percentage of the co-channel interference power against the maximum power.

The value is an integer that ranges from 1 to 100, in percentage.


2G radio profile view, 5G radio profile view

Default Level

2: Configuration level

Usage Guidelines

Two APs working in the same frequency band interfere with each other. For example, on a large-scale WLAN (a university campus network), different APs often use the same channel. When there are overlapping areas among these APs, co-channel interference exists, degrading network performance.

After the interference detect-enable command is executed to enable interference detection, an AP can detect adjacent-channel interference. When the AP detects that co-channel interference exceeds the alarm threshold configured using the interference co-channel threshold command, the AP sends an alarm to the AC.


# Set the alarm threshold for co-channel interference to 60%.

<HUAWEI> system-view
[HUAWEI] wlan 
[HUAWEI-wlan-view] radio-2g-profile name radio0
[HUAWEI-wlan-radio-2g-prof-radio0] interference detect-enable 
[HUAWEI-wlan-radio-2g-prof-radio0] interference co-channel threshold 60
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 123451

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next