No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
radio-type (5G radio profile view)

radio-type (5G radio profile view)


The radio-type command sets the radio type in a 5G radio profile.

The undo radio-type command restores the default radio type in a 5G radio profile.

By default, the radio type in a 5G radio profile is dot11ax.


radio-type { dot11a | dot11n | dot11ac | dot11ax }

undo radio-type






Specifies the 802.11a radio type.



Specifies the 802.11a/n radio type.



Specifies the 802.11a/n/ac radio type.



Specifies the 802.11a/n/ac/ax radio type.



5G radio profile

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

Usually, the default radio type is used and does not need to be modified. If the default radio mode cannot meet requirements or a fault needs to be located, configure the radio type as required.


When the radio type is set to dot11a, the function of denying access from non-HT STAs becomes invalid.

If the configured radio type is not supported by an AP, the actual radio type supported by the AP takes effect. For example, if you set the 802.11ac radio type for an 802.11n AP, the 802.11n radio type takes effect on the AP.

If WDS- or Mesh-enabled radios are configured not to support 802.11n/ac, the air interface backhaul performance will be degraded.


# Set the radio type to dot11n in a 5G radio profile.

<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] radio-5g-profile name default
[HUAWEI-wlan-radio-5g-prof-default] radio-type dot11n
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 123976

Downloads: 88

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next