No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
spectrum-analysis non-wifi-device aging-time

spectrum-analysis non-wifi-device aging-time


The spectrum-analysis non-wifi-device aging-time command configures the aging time of non-Wi-Fi devices on the AC during spectrum analysis.

The undo spectrum-analysis non-wifi-device aging-time command restores the default aging time of non-Wi-Fi devices on the AC during spectrum analysis.

By default, the aging time of non-Wi-Fi devices on the AC is 3 minutes.


spectrum-analysis non-wifi-device aging-time aging-time

undo spectrum-analysis non-wifi-device aging-time






Specifies the aging time of non-Wi-Fi devices on the AC.

The value is an integer that ranges from 1 to 30, in minutes.


AP system profile view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

When the AC is configured as the spectrum analysis server using the spectrum-analysis server command, the AC stores information about analyzed non-Wi-Fi devices. If an AP does not report information about a non-Wi-Fi device to the AC again within the aging time configured using the spectrum-analysis non-wifi-device aging-time command, the AC adds the non-Wi-Fi device to the historical list. You can run the display wlan non-wifi-device history command to check information about non-Wi-Fi devices in the historical list.


Currently, the AC cannot identify different devices of the same type. For example, when the AC detects two bluetooth devices: A and B, the AC can only record the devices as a bluetooth device and update the detection time of the bluetooth device.


# Set the aging time of non-Wi-Fi devices on the AC to 5 minutes.

<HUAWEI> system-view
[HUAWEI] wlan 
[HUAWEI-wlan-view] ap-system-profile name ap-system1
[HUAWEI-wlan-ap-system-prof-ap-system1] spectrum-analysis non-wifi-device aging-time 5
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 116836

Downloads: 83

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next