No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R013C00 Command Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).



The ap-id command adds an AP offline or displays the AP view.

By default, no AP is added offline.


ap-id ap-id [ [ type-id type-id | ap-type ap-type ] { ap-mac ap-mac | ap-sn ap-sn | ap-mac ap-mac ap-sn ap-sn } ]






Specifies the AP ID.

The value is an integer. The value range varies according to devices:
  • S12704, S12708, and S12712 (The main control unit is MPUA): 0 to 6143
  • S12704, S12708, and S12712 (The main control unit is MPUD): 0 to 10239
  • S12710: 0 to 6143

type-id type-id

Specifies the AP type ID.

The value is an integer that ranges from 0 to 255.

ap-type ap-type

Specifies the AP type.

The value is a string of 1 to 31 characters.

ap-mac ap-mac

Specifies the MAC address of an AP.

The value is in H-H-H format. An H is a hexadecimal number of 4 digits.

ap-sn ap-sn

Specifies the serial number (SN) of an AP.

The value is a string of 1 to 31 characters, and can only contain letters and digits.


WLAN view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

After an AP is successfully added to an AC, you can configure parameters for the AP offline. When the AP goes online, it uses the configured parameters.

You can run the undo ap command to delete an AP.


To add an AP, you must enter the MAC address, SN, or MAC address+SN. In MAC address authentication mode, enter the MAC address of the AP. In SN authentication mode, enter the SN of the AP.

To enter the AP view, you only need to enter the AP ID.


# Create an AP with ID 11, type ID 19, and MAC address 0025-9e07-8270.

<HUAWEI> system-view
[HUAWEI] wlan 
[HUAWEI-wlan-view] ap-id 11 type-id 19 ap-mac 0025-9e07-8270
Related Topics
Updated: 2019-04-09

Document ID: EDOC1100065659

Views: 115597

Downloads: 83

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next